|
Monday 19 February 2007 6:27:13 am
ImageMagic is installed in directory: /usr/lib/bin and the part of the output of the image.ini. is here. I would like to know what shall I write in this file. (I have changed ExecutablePath and ExecutableUnix values, but it didn't help)
best regards
Aleksandar
# -------- Image converter settings --------
#
[ShellSettings]
ConvertPath=
[ImageConverterSettings]
RepositoryList[]=lib/ezimage/classes
ExtensionList[]
# List of converters to use, each entry is the name of the converter
# which is defined in a ini block.
# The order of the convertes are important since the first
# applicable converter will be used. The last handler is
# usually a fallback converter which can take care of most formats.
# The list can also contain converters which cannot work
# on the installed server, the converter should check this
# and tell the image system to not use it.
ImageConverters[]
ImageConverters[]=ImageMagick
ImageConverters[]=GD
ImageHandlerAlias[]
[GD]
Name=GD
IsEnabled=true
# Which PHP handler to use for the conversion,
# ezimagegd means to use the ImageGD extension in PHP
Handler=ezimagegd
# The following filters are supported by GD
# geometry/scale
# geometry/scalewidth
# geometry/scaleheight
# geometry/scaledownonly
# geometry/scalewidthdownonly
# geometry/scaleheightdownonly
# geometry/scaleexact
# geometry/scalepercent
# geometry/crop
# colorspace/gray
# luminance/gray
# luminance/sepia
# color/monochrome
# border
# border/color
# border/width
[ImageMagick]
Name=ImageMagick
# If set to true then this handler will be used,
# The setup wizard will turn this off it ImageMagick is not found on the system
IsEnabled=true
# Which PHP handler to use for the conversion,
# ezimageshell means to use the generic shell handler which
# creates a command line and executes it with system().
Handler=ezimageshell
# The path to the executable, can be empty for global path.
ExecutablePath=/usr/local/bin/
# Name of the executable
Executable=convert
# Name of the executable for windows,
# uncomment ExecutableMac for Mac specific converter and
# ExecutableUnix for Unix/Linux specific converter
# ExecutableMac=convert
ExecutableUnix=convert
# Parameters that must be run before the filenames and filters.
PreParameters=
# Parameters that must be run after the filenames and filters.
PostParameters=
# Whether the destination name should be prefixed with a TAG name (see MIMETagMap below)
# The variable contains the separator between the TAG and the filename.
# This is needed for ImageMagick to provide proper conversions of some formats.
UseTypeTag=:
|
