Forums / Install & configuration / Errors after initial install

Errors after initial install

Author Message

Stian Sporaland

Friday 07 November 2003 9:23:09 am

Hi.

After running setup without any kinds of errors whatsoever, I try to run the user and/or admin part of the site, and all I get are these errors:

Fatal error: Maximum execution time of 30 seconds exceeded in c:\webroot\therat\forsand\lib\ezxml\classes\ezdomnode.php on line 441

Fatal error: Maximum execution time of 30 seconds exceeded in c:\webroot\therat\forsand\lib\ezutils\classes\ezexecution.php on line 157

Fatal error: Maximum execution time of 30 seconds exceeded in c:\webroot\therat\forsand\lib\ezutils\classes\ezsession.php on line 75

Warning: Unknown(): A session is active. You cannot change the session module's ini settings at this time. in Unknown on line 0

-----------------

Running Apache 1.3 and PHP 4.3

Anyone got a clue what's wrong?

Thanks in advance!

-Stian

Bill Van Vliet

Friday 07 November 2003 12:51:00 pm

Ran setup with no errors. Set up three demo sites. Unable to access any of them. Get 404 errors for both user and admin.

Glenn MacGregor

Friday 07 November 2003 1:31:02 pm

Are you using Apache 2.0? If so search the documentation for PATH_INFO. It is an Apache config setting that must be set for ezp to work with or without virtualhosts (I belive).

The info you need is in the docs under configuration->troubleshooting->404 -- Page not found.

Stian Sporaland

Friday 07 November 2003 2:30:18 pm

Oh yeah, I might mention for my problem: I am running virtual host mode.